HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide

Micro QR Code Enter/Exit Programming Mode
Programming Reference Guide 179
Micro QR Code Set Length 2
This feature specifies one of the barcode lengths for Micro QR Code Length Control. Length 2 is the maximum
label length if in Variable Length Mode, or the second fixed length if in Fixed Length Mode. Characters can be
set from 0001 to 0035 characters in increments of 0001 (pad with zeroes).
See page 193 for detailed instructions on setting this feature.
Select QR Code Length 2 Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D, Keypad
representing your desired character(s). End by scan-
ning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can then start
again at the beginning.
CANCEL
$CMQL2
~
DEFAULT
Length 2 is 0035 Characters