HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide

References

188 Programming Reference Guide

NAK Character

This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII characters or

any hex value from 0 to 0xFF can be selected.

To set this feature:

1. Determine the desired character or value.

2. Use the ASCII Chart on the inside back cover of this manual to find the hex equivalent for the desired

character/value.

3. Go to page 17 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

Mode.

4. Scan the barcode: SELECT NAK CHARACTER SETTING.

5. Scan the appropriate two alphanumeric characters from the keypad in Appendix D, Keypad, that repre-

sent the desired character/value in step 1 above. The second character will cause a two-beep indication.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.

This completes the procedure. See Table 27 for some examples of how to set this feature.

Table 27. NAK Character Setting Examples

STEP ACTION EXAMPLES

1 Desired Character/Value

NAK $ @ >

Hex equivalent from

ASCII

Chart

0x15 0x24 0x40 0x3E

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT NAK CHARACTER SETTING

Scan Two Characters From

Appendix D, Keypad

‘1’ and ‘5’ ‘2’ and ‘4’ ‘4’ and ‘0’ ‘3’ AND ‘E’

6 Scan ENTER/EXIT PROGRAMMING MODE