HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide

References

192 Programming Reference Guide

Enable Character

Specifies the value of the USB-COM host command used to enable the reader.

ASCII characters or any hex value from 0 to 0xFF can be selected.

To set this feature:

Determine the desired character or value. A setting of 0xFF indicates the Enable Character is not used (not

available).

1. Determine the desired character or value.

2. Use the ASCII Chart on the inside back cover of this manual to find the hex equivalent for the desired

character/value.

3. Go to page 20 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

Mode.

4. Scan the barcode: SELECT ENABLE CHARACTER SETTING.

5. Scan the appropriate two alphanumeric characters from the keypad in Appendix D, Keypad, that repre-

sent the desired character/value in step 2 above. The second character will cause a two-beep indication.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.

This completes the procedure. See Table 31 for some examples of how to set this feature.

Table 31. Enable Character Setting Examples

STEP ACTION EXAMPLES

1 Desired character/value

‘e’ ‘}’ ‘E’

Enable Command

Not Used

Hex equivalent from

ASCII

Chart

0x65 0x7D 0x45 0xFF

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT ENABLE CHARACTER VALUE SETTING

Scan Two Characters From

Appendix D, Keypad

‘6’ and ‘5’ ‘7’ and ‘D’ ‘4’ and ‘5’ ‘F’ AND ‘F’

6 Scan ENTER/EXIT PROGRAMMING MODE