HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide
References
200 Programming Reference Guide
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to page 37 and scan the ENTER/EXIT barcode.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suffix) by scanning
the appropriate barcode in the section "Label ID Control" on page 37. Reference Figure 4 for Label ID
positioning options if multiple identification features are enabled.
3. Scan a barcode to select the symbology for which you wish to configure a custom Label ID from the sec-
tion "Label ID Symbology Selection − 1D Symbologies" on page 38.
4. Determine the desired character(s) (you may choose up to three) which will represent the Label ID for the
selected symbology.
5. Turn to the ASCII Chart on the inside back cover of this manual and find the equivalent hex digits asso-
ciated with your choice of Label ID. For example, if you wish to select an equal sign (=) as a Label ID,
the chart indicates its associated hex characters as 3D. Turn to Keypad, starting on page 229 and scan the
barcodes representing the hex characters determined. For the example given, the characters ‘3’ and ‘D’
would be scanned. More examples of Label ID settings are provided in Table 33.
6. Scan the ENTER/EXIT barcode to exit Label ID entry.
7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 4. Label ID Position Options
If you make a mistake before the last character, scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the beginning.
OR
Prex SuxLabel ID Label IDBar Code DataAim ID