HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide

Enter/Exit Programming Mode
14 Programming Reference Guide
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and the beginning of the
next. The delay can be set within a range of zero (0) to 990 milliseconds in 10ms increments. A setting of zero
specifies no delay.
See page 186 for more information.
Beep On ASCII BEL
When this parameter is enabled, the reader issues a beep when a <BEL> character is detected on the RS-232
serial line. <BEL> is issued to gain a user's attention to an illegal entry or other important event.
Intercharacter Delay = No Delay
Select Intercharacter Delay Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D, Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
Beep On ASCII BEL = Disable
Beep On ASCII BEL = Enable
$CR2IC00(CR)
$CR2IC
~
DEFAULT
00 = No Intercharacter Delay
$CR2BB00(CR)
DEFAULT
$CR2BB01(CR)