HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide

Enter/Exit Programming Mode
Programming Reference Guide 53
Stand Mode Illumination Off Time
Specifies the amount of time reader illumination stays off after selecting the software trigger when in Stand
Mode. The configurable range is 01 to 32 by 01 in increments of 500ms (500ms to 16 seconds). See page 204
in “References” for a description of this feature.
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is entered. The
range for this setting is from 1 to 255 seconds in 1-second increments. See page 205 in “References” for further
description of this feature.
Select Stand Mode Time Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D, Keypad
representing your desired character(s). End by scan-
ning the ENTER/EXIT barcode again.
Scanning Active Time = 3 seconds
Scanning Active Time = 5 seconds
Scanning Active Time = 8 seconds
$CSNTM
DEFAULT
04 = 2 Seconds
$CSNET03(CR)
$CSNET05(CR)
DEFAULT
$CSNET08(CR)