HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide

Enter/Exit Programming Mode
54 Programming Reference Guide
Stand Illumination Control
Controls the illumination status while the reading mode is stand mode and the reader is attempting to detect
objects.
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode. The selectable range is 100 to
9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See page 207 in “References” for
detailed information on setting this feature.
Stand Illumination Control = OFF
Stand Illumination Control = ON
Stand Illumination Control = Dim
Select Flash ON Time Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D, Keypad
representing your desired character(s). End by scan-
ning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
$CSMIL00(CR)
$CSMIL01(CR)
$CSMIL02(CR)
$CSNFN
~
DEFAULT
10 = Flash is ON for 1 Second