HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide

Enter/Exit Programming Mode
Programming Reference Guide 55
Flash Off Time
This feature specifies the OFF time for the indicator LED while in Flash Mode. The selectable range is 100 to
9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See page 208 in “References” for
detailed information on setting this feature.
Illumination: Brightness
This feature specifies the brightness of the illumination LEDs during scanning.
Select Flash OFF Time Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in Appendix D, Keypad
representing your desired character(s). End by scan-
ning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can then start
again at the beginning.
CANCEL
HIgh Brightness
Medium Brightness
Low Brightness
$CSNFF
~
DEFAULT
06 = Flash is OFF for 600ms
DEFAULT