HP Integrated Barcode Scanner HP Integrated Barcode Scanner Programming Reference Guide

Enter/Exit Programming Mode

56 Programming Reference Guide

Aiming Pointer

Enables/disables the aiming pointer for all symbologies.

Aiming Duration Timer

Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger single

mode.The range for this setting is from 1 to 255 seconds in 1-second increments. See page 206 in “References”

for a description of this feature.

Reducing the LED brightness can reduce scanning performance.

Aiming Pointer = Disable

Aiming Pointer = Enable

Aiming Off After Decoding

Set Aiming Duration Timer

To configure, scan the ENTER/EXIT PROGRAM-

MING MODE barcode above, then the barcode at

left followed by the digits from the Alphanumeric

characters in Appendix D, Keypad representing

your desired character(s). End by scanning the

ENTER/EXIT barcode.

Make a mistake? Scan the CANCEL barcode to

abort and not save the entry string. You can then start

again at the beginning.

CANCEL

$CTAAP00(CR)

$CTAAP01(CR)

DEFAULT

LSTM00

LSTM