Maintenance and Service Guide

Hard drive
Description Spare part number
1 TB, 7200 RPM, 9.5 mm 766644-002
1 TB, 7200 RPM, locked, Hitachi (for EMEA region) 932468-002
500 GB, 7200 RPM 703267-002
500 GB, 5400 RPM, hybrid 8 GB cache, 7 mm 732000-002
500 GB, 7200 RPM FIPS, 7 mm 820572-002
500 GB, 7200 RPM, SED, 7 mm 820573-002
Hard drive for use in standard models
NOTE: The hard drive spare kit does not include the hard drive bracket or hard drive cable. The hard drive
bracket, screws, and hard drive cable are included in the Hard Drive Hardware Kit, spare part number
848351-001 for standard models.
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see Service door on page 36).
5. Disconnect the battery cable from the system board (see Battery on page 39).
Remove the hard drive:
1. Lift the hard drive connector (1), and then release the hard drive cable (2) from the guide.
2. Loosen the four captive screws (3) that secure the hard drive to the computer.
42 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts