User Guide

3 Setting up the monitor
To set up the monitor, ensure that the power is turned o to the monitor, computer system, and other
attached devices, then follow the instructions below.
NOTE: Be sure the master power switch, located on the rear panel of the monitor, is in the o position. The
master power switch turns o all power to the monitor.
Use caution when setting up the monitor
To prevent damage to the monitor, do not touch the surface of the LCD panel. Pressure on the panel may
cause non-uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover
to its normal condition.
If installing a base, lay the monitor face down on a at surface covered with a protective sheet foam or non-
abrasive cloth. This prevents the screen from getting scratched, defaced or broken as well as damage to the
front panel buttons.
Attaching the monitor stand
IMPORTANT: Do not touch the surface of the LCD panel. Pressure on the panel may cause non-uniformity of
color or disorientation of the liquid crystals. If this occurs the screen will not recover to its normal condition.
The display uses the HP Quick Release 2 for easy moving of the monitor. To mount the panel onto the stand:
1. Lay the monitor panel face down on a at surface covered by a clean, dry cloth.
2. Slide the top of the mounting plate (1) on the stand under the upper lip of the recess in the back of the
panel.
3. Lower the bottom of the stand's mounting plate (2) into the recess until it snaps into place.
4. The HP Quick Release 2 latch (3) pops up when the stand is locked in place.
Use caution when setting up the monitor 5