User Guide

Removing the monitor stand
You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other
mounting xture.
IMPORTANT: Before beginning to disassemble the monitor, be sure the monitor is turned o and the power
and signal cables are both disconnected. Also disconnect any other cables connected to the monitor.
1. Disconnect and remove the signal, power, and USB cables from the monitor.
2. Lay the monitor face down on a at surface covered by a clean, dry cloth.
3. Press down on the latch near the bottom center of the monitor to unlock the HP Quick Release 2 (1).
4. Swing the bottom of the stand up until the mounting plate clears the recess in the panel (2).
5. Slide the stand out of the recess (3).
Mounting the monitor
The monitor panel can be attached to a wall, swing arm, or other mounting xture.
You can attach the monitor panel to a mounting xture using the HP Quick Release 2 mounting bracket on the
stand or you can attach the monitor panel to a mounting xture without the use of the HP Quick Release 2
mounting bracket on the stand.
NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.
IMPORTANT: This monitor supports the VESA industry standard 100 mm mounting holes. To attach a third-
party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are required. Longer
screws must not be used because they may damage the monitor. It is important to verify that the
manufacturer’s mounting solution is compliant with the VESA standard and is rated to support the weight of
the monitor display panel. For best performance, it is important to use the power and video cables provided
with the monitor.
16 Chapter 3 Setting up the monitor