HP EliteOne 800 G3 All-in-One Business PC - Maintenance & Service Guide

WLAN module
Description
Intel Dual Band Wireless-AC 7265 NV
Intel 3168 ac 1x1 +Bluetooth 4.2LE M.2 non-vPro PCI-e+USB WW with 2 antennas
Intel 8265 ac 2x2 +Bluetooth 4.2 M.2 non-vPro PCI-e+USB WW with 2 antennas
Intel 8265 ac 2x2 +Bluetooth 4.2 M.2 vPro PCI-e+USB WW with 2 antennas
Realtek RTL8723BE bgn 1x1 + Bluetooth 4 LE PCIe+USB NGFF 2230 M.2 WW
The WLAN module is located on the system board above the memory modules. The WLAN module is secured
with one Phillips screw and has two connected antennas.
NOTE: The procedure to replace the WLAN module must be performed by an HP technician.
NOTE: WLAN module appearance may vary.
To remove the WLAN module:
1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 19).
2. Remove the rear port cover (see Removing the rear port cover on page 19).
3. Remove the stand (see Stands on page 20).
4. Remove the access panel (see Access panel on page 21).
5. Disconnect the antenna cables from the module (1).
6. Remove the Phillips screw (2) that secures the module to the computer.
WLAN module 31