Maintenance and Service Guide

d. Release the antenna cables from the routing channels (2) built into the display back cover.
e. Remove the WLAN antenna cables and transceivers.
The WLAN antenna(s) are available using spare part number L93206-001.
Reverse this procedure to reassemble and install the display assembly.
Power connector cable
Table
5-10 Power connector cable spare part information
Description Spare part number
Power connector cable L93195-001
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 25).
5. Disconnect the battery from the system board (see Front speakers on page 27).
6. Remove the display assembly (see Display assembly on page 39).
Remove the power connector cable:
1. Disconnect the power connector cable cable (1) from the system board.
46 Chapter 5 Removal and replacement procedures