HP ThinPro 5.0 - Administrator Guide

Table E-13 root > Display (continued)
Registry key Description
root/Display/Configuration/hexprofile Specifies the profile used in six-monitor mode. See the
displaymode key.
root/Display/Configuration/primaryprofile This must always be set to default.
root/Display/Configuration/quaternarymode If supported, specifies the position of the fourth monitor
relative to the primary monitor.
0—Same As
1—Above
2—Right Of
3—Left Of
4—Below
5—None
NOTE: This is hardware dependent and is not supported
on all models. The HP t5335z does not support two monitors.
root/Display/Configuration/quaternaryprofile Specifies the profile name used for the fourth monitor.
root/Display/Configuration/quaternaryrelative Indicates which monitor is referenced to set the position of
the fourth monitor. See the tertiarymode key.
root/Display/Configuration/secondaryConnector Specifies the secondary connector.
root/Display/Configuration/secondarymode If supported, specifies the position of the secondary monitor
relative to the primary monitor.
0—Same As
1—Above
2—Right Of
3—Left Of
4—Below
5—None
NOTE: This is hardware dependent and is not supported
on all models. The HP t5335z does not support two monitors.
root/Display/Configuration/secondaryorientation
root/Display/Configuration/secondaryprofile Specifies the profile name used for the second monitor.
root/Display/Configuration/swapstate Specifies which connector contains the primary monitor. This
is hardware-dependent and might not be implemented on all
models. Generally, 0 means the primary monitor is on the
VGA connector and 1 means the 'other' connector. For the
HP t5565z, 0 means the primary is on the DVI-I connector
and 1 means the primary is on the DVI-D connector. The HP
t5335z does not support two monitors.
root/Display/Configuration/tertiarymode If supported, specifies the position of the third monitor
relative to the primary monitor.
0—Same As
1—Above
124 Appendix E Registry keys