HP ThinPro 5.0 - Administrator Guide

Table E-13 root > Display (continued)
Registry key Description
2—Right Of
3—Left Of
4—Below
5—None
NOTE: This is hardware dependent and is not supported
on all models. The HP t5335z does not support two monitors.
root/Display/Configuration/tertiaryprofile Specifies the profile name for the third monitor.
root/Display/Configuration/tertiaryrelative Indicates which monitor is referenced to set the position of
the third monitor. See the tertiarymode key.
root/Display/Profiles/{UUID}/colorScaling The color temperature or direct RGB scaling for thin clients
with built-in monitors. The entry is a six-digit hex value
RRGGBB, where ffffff would indicate full (100%) scaling on
all three color channels.
root/Display/Profiles/{UUID}/depth The display bit depth per pixel. A higher bit depth means
better quality, but more data and thus a lower performance.
root/Display/Profiles/{UUID}/height The desired monitor resolution height. A value of 0 means
auto-detect the resolution.
root/Display/Profiles/{UUID}/label Display profile name. This should be default.
root/Display/Profiles/{UUID}/orientation Specifies monitor orientation:
0—Normal
1—Rotate left
2—Rotate right
3—Invert
root/Display/Profiles/{UUID}/refresh Specifies the desired monitor refresh rate; not all refresh
rates are supported for all resolutions. The values supported
by the client depend on the monitor. A value of 0 means
auto-detect the refresh rate.
IMPORTANT: Picking a refresh rate that is not supported
by the monitor attached to the client results in a black
screen. HP recommends leaving this set to 0.
root/Display/Profiles/{UUID}/width The desired monitor resolution width. A value of '0' means
auto-detect the resolution.
root/Display/userLock If set to 1 and the display settings have been modified by the
user, then the display settings are preserved and the profile’s
settings are discarded.
root/Display/userLockEngaged Flag set to 1 after a user modification. If set to 1 as well as
userLock, then the display settings are preserved and the
profiles settings are discarded. This key should not need to
be modified.
root > Display 125