HP ThinPro 5.0 - Administrator Guide

Option Description
Enable IPv6 Enables IPv6. IPv4 is used by default, and they cannot be used at the same time.
Enable Power Management Enables the power management feature for the wireless adapter.
Connection Method Lets you select between Automatic and Static. If your network environment is using DHCP,
then the Automatic option should work without any further configurations.
If Static is selected, the Static Address Configuration settings will become available. Be sure
to input these values according to whether you are using IPv4 or IPv6.
Security Settings Lets you set the authentication setting to one of the following:
●
None
●
WEP
●
WPA/WPA2-PSK
●
802.1X-TTLS
●
802.1X-PEAP
●
802.1X-TLS
●
EAP FAST
For WEP and WPA/WPA2-PSK, you just need to enter the network key and click OK.
For EAP-FAST, set Anonymous Identity, Username, Password, and Provisioning Method. You
do not need to change the PAC file settings.
See
Wired network settings on page 15 for more information about TTLS, PEAP, and TLS.
DNS settings
The following table describes the options available in the DNS tab of the Network Manager.
Option Description
Hostname This is generated automatically according to the MAC address of the thin client. You can
alternatively set a custom hostname.
DNS Servers Use this box to set custom DNS server information.
Search Domains Use this box to restrict the domains that are searched.
HTTP Proxy
FTP Proxy
HTTPs Proxy
Use these boxes to set proxy server information using the following format:
http://<ProxyServer>:<Port>
HP recommends using the http:// prefix for all three proxy settings because it is supported
better.
NOTE: The proxy settings are set to the http_proxy, ftp_proxy, and https_proxy
environmental variables for the system.
IPSec rules
Use this tab to add, edit, and delete IPSec rules. An IPSec rule should be the same for each system
that uses IPSec to communicate.
16 Chapter 4 Control Panel configurations