HP ThinPro 5.1 - Administrator Guide

Table E-13 root > Display (continued)
Registry key Description
root/Display/Configuration/secondaryConnector
Sets the secondary connector.
root/Display/Configuration/secondarymode
Sets the position of the secondary monitor relative to the
primary monitor. This is hardware-dependent and is not
supported on all models. Values are defined as follows:
0=Same As; 1=Above; 2=Right Of; 3=Left Of; 4=Below.
root/Display/Configuration/
secondaryorientation
This registry key is either used internally or reserved for
future use. The value should not be changed.
root/Display/Configuration/secondaryprofile
Sets the profile to use for the secondary monitor via the
profile name.
root/Display/Configuration/swapstate
Specifies which connector is connected to the primary
monitor. This is hardware-dependent and is not supported on
all models. Generally, 0 means the primary monitor is on the
VGA connector and 1 means the other connector. For the
t510, 0 means the primary monitor is on the DVI-I connector,
and 1 means the primary monitor is on the DVI-D connector.
For platforms with an add-on video card, 0 means the
primary monitor is on the built-in video card, and 1 means
the primary monitor is on the add-on video card.
root/Display/Configuration/tertiarymode
Sets the position of the third monitor relative to the monitor
indicated in tertiaryrelative. This is hardware-
dependent and is not supported on all models. Values are
defined as follows: 0=Same As; 1=Above; 2=Right Of; 3=Left
Of; 4=Below.
root/Display/Configuration/tertiaryprofile
Sets the profile to use for the third monitor via the profile
name.
root/Display/Configuration/tertiaryrelative
Sets which monitor is used as a reference to set the position
of the third monitor.
root/Display/Profiles/<UUID>/colorScaling
Sets the color temperature or direct RGB scaling for thin
clients with built-in monitors. The entry is a 6-digit hex value
(RRGGBB), where ffffff would indicate full (100%)
scaling on all three color channels.
root/Display/Profiles/<UUID>/depth
Sets the display color depth in bits-per-pixel. A higher color
depth means better quality but lower performance.
root/Display/Profiles/<UUID>/height
Sets the monitor resolution height. If set to 0, the resolution
is auto-detected.<
root/Display/Profiles/<UUID>/label
Sets the display profile name. For Smart Zero, this must
always be set to default.
root/Display/Profiles/<UUID>/orientation
Sets the monitor orientation as follows: 0=Normal; 1=Rotate
Left; 2=Rotate Right; 3=Invert.
root/Display/Profiles/<UUID>/refresh
Sets the desired monitor refresh rate. Not all refresh rates
are supported for all resolutions. If set to 0, the refresh rate is
auto-detected. The supported values are dependent on the
monitor. Setting a refresh rate that is not supported by the
attached monitor will lead to a black screen. HP
recommends leaving this set to 0.
root/Display/Profiles/<UUID>/width
Sets the monitor resolution width. If set to 0, the resolution is
auto-detected.
130 Appendix E Registry keys