HP ThinPro 5.2 - Administrator Guide

Table E-14 root > Dashboard (continued)
Registry key Description
root/Dashboard/General/EnterLeaveTimeout
Sets the amount of time in milliseconds before the taskbar will
hide or show when AutoHide is enabled.
root/Dashboard/General/IconSize
Sets the size of the icons on the taskbar.
root/Dashboard/General/Length
Sets the length of the taskbar.
root/Dashboard/General/LengthToScreenSide
If set to 1, the length of taskbar is xed and equal to the length of
the side of the screen to which it is anchored.
root/Dashboard/General/PanelDockSide
Sets the side of the screen to which the taskbar is docked.
root/Dashboard/General/RemainPixel
Sets the number of pixels that are still visible when the taskbar
hides.
root/Dashboard/General/SlidingTimeout
Sets the amount of time in milliseconds that it takes for the
taskbar to hide or show when AutoHide is enabled.
root/Dashboard/General/Width
Sets the width of the taskbar.
root > Display
Table E-15 root > Display
Registry key Description
root/Display/Configuration/AMDOptions/
SWCursor
If set to 1, a software-rendered mouse cursor is used, which
might x issues such as cursor corruption but can introduce issues
with multimedia playback and touch screens. If set to 0, a
hardware-rendered mouse cursor is used, which xes issues with
multimedia playback and touch screens.
root/Display/Configuration/displaymode
Sets the display mode. If set to 0, the standard mode (a 1–4
monitor conguration) is used. If set to 1, a 6-monitor
conguration can be used, but only on supported platforms with
the appropriate add-on card.
root/Display/Configuration/hexlayout
Sets the layout in 6-monitor mode.
root/Display/Configuration/hexprofile
Sets the prole used in 6-monitor mode.
root/Display/Configuration/primaryprofile
Sets the prole to use for the primary monitor via the prole
name. For Smart Zero, this must always be set to default.
root/Display/Configuration/quaternarymode
Sets the position of the fourth monitor relative to the monitor
indicated in quaternaryrelative. This is hardware-
dependent and is not supported on all models. Values are dened
as follows: 0=Same As; 1=Above; 2=Right Of; 3=Left Of; 4=Below.
root/Display/Configuration/quaternaryprofile
Sets the prole to use for the fourth monitor via the prole name.
root/Display/Configuration/quaternaryrelative
Sets which monitor is used as a reference to set the position of
the fourth monitor.
root/Display/Configuration/secondaryConnector
Sets the secondary connector.
root/Display/Configuration/secondarymode
Sets the position of the secondary monitor relative to the primary
monitor. This is hardware-dependent and is not supported on all
models. Values are dened as follows: 0=Same As; 1=Above;
2=Right Of; 3=Left Of; 4=Below.
132 Appendix E Registry keys