HP ThinPro 5.2 - Administrator Guide

Table E-16 root > Network (continued)
Registry key Description
mydomain.com will allow the server denition myserver to
resolve properly to myserver.mydomain.com, even if the
DNS server does not have
myserver in its name resolution
tables. Up to ve additional search domains can be specied.
root/Network/VPN/AutoStart
If set to 1, VPN starts automatically when the system starts up.
root/Network/VPN/PPTP/Domain
Sets the PPTP domain.
root/Network/VPN/PPTP/Gateway
Sets the PPTP gateway.
root/Network/VPN/PPTP/Password
Sets the PPTP user password.
root/Network/VPN/PPTP/Username
Sets the PPTP username.
root/Network/VPN/Type
Sets the VPN type.
root/Network/VPN/VPNC/Domain
Sets the VPNC domain.
root/Network/VPN/VPNC/Gateway
Sets the VPNC gateway.
root/Network/VPN/VPNC/Group
Sets the VPNC group.
root/Network/VPN/VPNC/GroupPassword
Sets the VPNC group password.
root/Network/VPN/VPNC/IKEDHGroup
Sets the VPNC IKE Die-Hellman group.
root/Network/VPN/VPNC/LocalUDPPort
Sets the local UDP port to use for VPNC. If set to 0, a random port
will be used. This setting is valid only when the NAT traversal
mode (NATTMode) is cisco-udp.
root/Network/VPN/VPNC/NATTMode
Sets the VPNC NAT traversal mode.
root/Network/VPN/VPNC/Password
Sets the VPNC user password.
root/Network/VPN/VPNC/PerfectForwardSecrecy
Sets the VPNC Die-Hellman group to use for Perfect Forward
Secrecy (PFS).
root/Network/VPN/VPNC/Security
Sets the VPNC security level.
root/Network/VPN/VPNC/Username
Sets the VPNC username.
root/Network/Wired/DefaultGateway
Sets the default gateway the device will use to communicate with
the Internet. Typically this is the IP address of the router. This
setting will only take eect when Method is set to Static.
root/Network/Wired/EnableDefGatewayAsDNS
If set to 1, the default gateway will also be the name server.
root/Network/Wired/EthernetSpeed
Sets the link speed of the primary Ethernet network interface.
Automatic allows the fastest available link speed to be used,
which is usually 1 Gbps or 100 Mbps/Full depending on the switch.
The link speed can also be forced to a single speed (100 Mbps or
10 Mbps) and duplex mode (Full or Half) to support switches and
hubs that do not perform appropriate auto-negotiation.
root/Network/Wired/IPAddress
Sets the IPv4 address of the thin client. This setting will only take
eect when Method is set to Static.
root/Network/Wired/IPv6Enable
If set to 1, IPv6 is enabled.
root/Network/Wired/Interface
Sets the default Ethernet interface or NIC.
root/Network/Wired/MTU
Sets the MTU. It does not matter if the IP address is static or
DHCP-acquired.
136 Appendix E Registry keys