HP ThinPro 5.2 - Administrator Guide

Using smart card redirection with RDP
By default, smart cards will be redirected using high-level redirection, allowing them to be used to log in to
the session and other remote applications.
To enable smart card login for an RDP connection:
▲
Select Allow Smartcard Login in the RDP Connection Manager.
This will allow the user to connect without rst specifying credentials. The RDP client will start the RDP
session, and the user will be prompted to authenticate by smart card.
This technology requires drivers for the smart card reader driver to be installed on the thin client. By default,
the CCID and Gemalto drivers are installed, which adds support for the majority of smart card readers
available. Additional drivers can be installed by adding them to /usr/lib/pkcs11/.
NOTE: When smart card login is enabled, Network Level Authentication is not supported and is
automatically disabled.
44 Chapter 7 RDP connections