HP ThinPro 6.1 - Administrator Guide
Registry key Description
root/Display/Configuration/hexlayout
Sets the layout in 6-monitor mode.
root/Display/Configuration/hexprofile
Sets the prole used in 6-monitor mode.
root/Display/Configuration/primaryprofile
Sets the prole to use for the primary monitor via the prole
name. For Smart Zero, this must always be set to default.
root/Display/Configuration/quaternarymode
Sets the position of the fourth monitor relative to the monitor
indicated in quaternaryrelative. This is hardware-
dependent and is not supported on all models. Values are dened
as follows: 0=Same As; 1=Above; 2=Right Of; 3=Left Of; 4=Below.
root/Display/Configuration/quaternaryprofile
Sets the prole to use for the fourth monitor via the prole name.
root/Display/Configuration/quaternaryrelative
Sets which monitor is used as a reference to set the position of
the fourth monitor.
root/Display/Configuration/secondaryConnector
Sets the secondary connector.
root/Display/Configuration/secondarymode
Sets the position of the secondary monitor relative to the primary
monitor. This is hardware-dependent and is not supported on all
models. Values are dened as follows: 0=Same As; 1=Above;
2=Right Of; 3=Left Of; 4=Below.
root/Display/Configuration/
secondaryorientation
This registry key is either used internally or reserved for future
use. The value should not be changed.
root/Display/Configuration/secondaryprofile
Sets the prole to use for the secondary monitor via the prole
name.
root/Display/Configuration/swapstate
Species which connector is connected to the primary monitor.
This is hardware-dependent and is not supported on all models.
Generally, 0 means the primary monitor is on the VGA connector
and 1 means the other connector. For the t510, 0 means the
primary monitor is on the DVI-I connector, and 1 means the
primary monitor is on the DVI-D connector. For platforms with an
add-on video card, 0 means the primary monitor is on the built-in
video card, and 1 means the primary monitor is on the add-on
video card.
root/Display/Configuration/tertiarymode
Sets the position of the third monitor relative to the monitor
indicated in tertiaryrelative. This is hardware-dependent
and is not supported on all models. Values are dened as follows:
0=Same As; 1=Above; 2=Right Of; 3=Left Of; 4=Below.
root/Display/Configuration/tertiaryprofile
Sets the prole to use for the third monitor via the prole name.
root/Display/Configuration/tertiaryrelative
Sets which monitor is used as a reference to set the position of
the third monitor.
root/Display/Profiles/<UUID>/colorScaling
Sets the color temperature or direct RGB scaling for thin clients
with built-in monitors. The entry is a 6-digit hex value (RRGGBB),
where ffffff would indicate full (100%) scaling on all three
color channels.
root/Display/Profiles/<UUID>/depth
Sets the display color depth in bits-per-pixel. A higher color depth
means better quality but lower performance.
root/Display/Profiles/<UUID>/height
Sets the monitor resolution height. If set to 0, the resolution is
auto-detected.
root/Display/Profiles/<UUID>/label
Sets the display prole name. For Smart Zero, this must always be
set to default.
Display 123