HP ThinPro 6.1 - Administrator Guide

Registry key Description
root/Network/Wired/DefaultGateway
Sets the default gateway the device will use to communicate with
the Internet. Typically this is the IP address of the router. This
setting will only take eect when Method is set to Static.
root/Network/Wired/EnableDefGatewayAsDNS
If set to 1, the default gateway will also be the name server.
root/Network/Wired/EthernetSpeed
Sets the link speed of the primary Ethernet network interface.
Automatic allows the fastest available link speed to be used,
which is usually 1 Gbps or 100 Mbps/Full depending on the switch.
The link speed can also be forced to a single speed (100 Mbps or
10 Mbps) and duplex mode (Full or Half) to support switches and
hubs that do not perform appropriate auto-negotiation.
root/Network/Wired/IPAddress
Sets the IPv4 address of the thin client. This setting will only take
eect when Method is set to Static.
root/Network/Wired/IPv6Enable
If set to 1, IPv6 is enabled.
root/Network/Wired/Interface
Sets the default Ethernet interface or NIC.
root/Network/Wired/MTU
Sets the MTU. It does not matter if the IP address is static or
DHCP-acquired.
root/Network/Wired/Method
If set to Automatic, the thin client will use DHCP to attempt to
retrieve network settings. If set to Static, the values of the
IPAddress, SubnetMask, and DefaultGateway registry
keys are used. HP does not recommend using Static in a
generic client prole because it will cause all thin clients to
receive the same IP address.
root/Network/Wired/Security/CACert
Sets the path to CA certicate le.
root/Network/Wired/Security/EnableMachineAuth
If set to 1, machine authentication for PEAP is enabled.
root/Network/Wired/Security/Identity
Sets the identity or anonymous identity.
root/Network/Wired/Security/InnerAuth
Sets the PEAP inner authentication protocol.
root/Network/Wired/Security/InnerAuthTTLS
Sets the TTLS inner authentication protocol.
root/Network/Wired/Security/MachineAuthName
Stores the machine account name when machine authentication is
enabled.
root/Network/Wired/Security/
MachineAuthPassword
Stores the machine account password when machine
authentication is enabled.
root/Network/Wired/Security/PEAPVersion
Sets the PEAP version.
root/Network/Wired/Security/Password
Sets the password.
root/Network/Wired/Security/PrivateKey
Sets the path to a private key le. This is only used for TLS
authentication.
root/Network/Wired/Security/Type
Sets the 802.1x authentication type.
root/Network/Wired/Security/UserCert
Sets the path to a user certicate le. This is only used for TLS
authentication.
root/Network/Wired/Security/Username
Sets the username.
root/Network/Wired/SubnetMask
Sets the subnet mask of the device, such as 255.255.255.0 (for a
standard class C subnet). This setting will only take eect when
Method is set to Static.
Network 127