HP ThinPro 6.1 - Administrator Guide

Option Description
●
802.1X-TLS
Note the following about TTLS and PEAP:
●
The Inner Authentication option should be set to whatever your server supports.
●
The CA Certicate setting should point to the server’s certicate on the local thin client.
●
The Username and Password are the user’s credentials.
Note the following about TLS:
●
The CA Certicate setting should point to the server’s certicate on the local thin client.
●
If your Private Key le is .p12 or .pfx, then the User Certicate setting can be left blank.
●
The Identity setting should be the username that corresponds to the user certicate.
●
The Private Key Password setting is the password of the user’s private key le.
Wireless network settings
The following table describes the options available in the Wireless tab of the Network Manager.
NOTE: This tab is available only if the thin client has a wireless adapter.
Option Description
Scan AP Scans for available wireless networks.
SSID Use this box to manually enter the SSID of the wireless network if it is not found by the scan.
SSID Hidden Enable this option if the SSID of the wireless network is set to be hidden (not broadcasting).
Enable IPv6 Enables IPv6. IPv4 is used by default, and they cannot be used at the same time.
Enable Power Management Enables the power management feature for the wireless adapter.
Connection Method Lets you select between Automatic and Static. If your network environment is using DHCP, then the
Automatic option should work without any further congurations.
If Static is selected, the Static Address Conguration settings will become available. Be sure to input
these values according to whether you are using IPv4 or IPv6.
Security Settings Lets you set the authentication setting to one of the following:
●
None
●
WEP
●
WPA/WPA2-PSK
●
802.1X-TTLS
●
802.1X-PEAP
●
802.1X-TLS
●
EAP FAST
For WEP and WPA/WPA2-PSK, you just need to enter the network key and select OK.
For EAP-FAST, set Anonymous Identity, Username, Password, and Provisioning Method. You do not
need to change the PAC le settings.
See Wired network settings on page 43 for more information about TTLS, PEAP, and TLS.
44 Chapter 5 Control Panel