HP ThinPro 6.2 - Administrator Guide

Registry key Description
root/Network/Wired/IPv6Enable
If set to 1, IPv6 is enabled.
root/Network/Wired/Interface
Sets the default Ethernet interface or NIC.
root/Network/Wired/MTU
Sets the MTU. It does not matter if the IP address is static or
DHCP-acquired.
root/Network/Wired/Method
If set to Automatic, the thin client will use DHCP to attempt to
retrieve network settings. If set to Static, the values of the
IPAddress, SubnetMask, and DefaultGateway registry
keys are used. HP does not recommend using Static in a
generic client prole because it will cause all thin clients to
receive the same IP address.
root/Network/Wired/Profiles/<UUID>/
AutoConnect
If set to 1, automatic connection to the network is enabled.
root/Network/Wired/Profiles/<UUID>/
EthernetSpeed
Sets the link speed of the primary Ethernet network interface.
Automatic allows the fastest available link speed to be used,
which is usually 1 Gbps or 100 Mbps/full depending on the switch.
The link speed can be forced to a combination of a single speed
(100 Mbps or 10 Mbps) and duplex mode (Full or Half) to
support switches and hubs that do not perform auto-negotiation.
root/Network/Wired/Profiles/<UUID>/IPv4/
Address
Sets the IPv4 address of the client. This setting takes eect only if
Method is set to Static.
root/Network/Wired/Profiles/<UUID>/IPv4/
DefaultGateway
Sets the default gateway that the device uses to communicate
with the Internet. Typically, this is the IP address of the router.
This setting takes eect only if Method is set to Static.
root/Network/Wired/Profiles/<UUID>/IPv4/
Enabled
If set to 1, IPv4 is enabled for this prole.
root/Network/Wired/Profiles/<UUID>/IPv4/
Method
If set to Automatic, the client uses DHCP to attempt to retrieve
network settings. If set to Static, the values of the Address,
SubnetMask, and DefaultGateway registry keys are used.
HP does not recommend using Static in a generic client prole,
because all clients would use the same IP address.
root/Network/Wired/Profiles/<UUID>/IPv4/
SubnetMask
Sets the subnet mask of the device, such as 255.255.255.0 (for a
standard class C subnet). This setting takes eect only if Method
is set to Static.
root/Network/Wired/Profiles/<UUID>/IPv6/
Address
Sets the IPv6 address of the client. This setting takes eect only if
Method is set to Static.
root/Network/Wired/Profiles/<UUID>/IPv6/
DefaultGateway
Sets the default gateway that the device uses to communicate
with the Internet. Typically, this is the IP address of the router.
This setting takes eect only if Method is set to Static.
root/Network/Wired/Profiles/<UUID>/IPv6/
Enabled
If set to 1, IPv6 is enabled for this prole.
root/Network/Wired/Profiles/<UUID>/IPv6/
Method
If set to Automatic, the client uses DHCP to attempt to retrieve
network settings. If set to Static, the values of the Address,
SubnetMask, and DefaultGateway registry keys are used.
HP does not recommend using Static in a generic client prole,
because all clients would use the same IP address.If set to
Automatic, the client uses DHCP to attempt to retrieve network
settings. If set to Static, the values of the Address,
SubnetMask, and DefaultGateway registry keys are used.
Network 135