HP ThinPro 6.2 - Administrator Guide

Option Description
●
802.1X-PEAP
●
802.1X-TLS
●
EAP-FAST
For WEP and WPA/WPA2-PSK, you just need to enter the network key and select OK.
For EAP-FAST, set Anonymous Identity, Username, Password, and Provisioning Method. You do not
need to change the PAC le settings.
See Wired network settings on page 46 for more information about TTLS, PEAP, and TLS.
Auto Connect This option is reserved for future use.
Enable Wireless Enables the wireless adapter.
Use the IPv4 tab to congure IPv4 connection settings.
Option Description
IPv4 Enabled Enables IPv4.
IPv4 Method Lets you select between Automatic and Static. If your network environment is using DHCP, then the
Automatic option should work without any further congurations.
If Static is selected, the Static Address Conguration settings are displayed, and you must enter the
IPv4 settings.
Use the IPv6 tab to congure IPv6 connection settings.
Option Description
IPv6 Enabled Enables the usage of an IPv6 global address.
NOTE: HP ThinPro tries to obtain an IPv6 global address via route advertisement or DHCPv6.
IPv6 Method Lets you select between Automatic and Static. If your network environment is using DHCP, then the
Automatic option should work without any further congurations.
If Static is selected, the Static Address Conguration settings are displayed, and you must enter the
IPv6 settings.
Use the Security tab to congure the connection security settings.
Option Description
Authentication Lets you set the authentication setting to one of the following:
●
None
●
WEP
●
WPA/WPA2-PSK
●
WPA/WPA2 Enterprise-TTLS
●
WPA/WPA2 Enterprise-PEAP
●
WPA/WPA2 Enterprise-TLS
48 Chapter 7 Control Panel