HP ThinPro 6.2 - Administrator Guide
NOTE: The port you need is in the section of ports labeled TS###, where ### is a number between
000–009, 033–044. The appropriate port depends on your hostname and the printer you want to install.
For example, with a hostname of ZTAHENAKOS and a serial printer, select the port with
(ZTAHENAKOS:COM1). For a parallel printer, select (ZTAHENAKOS:LPT1). The TS### is assigned by the
server, so it will not be the same every time.
6. Select the manufacturer and driver for your printer.
TIP: If desired, use the driver disc Windows Update to install the driver.
NOTE: For basic or test printing, the Generic Manufacturer or Generic/Text Only printer usually
works.
7. If prompted to keep the existing driver and it is known to work, keep it, and then select Next.
8. Assign a name to the printer. To use it as the default printer, select Yes, and then select Next.
9. To share the printer, select Share name and assign it a share name. Otherwise, select Next.
10. On the next page, you may request a test print. HP recommends this because it will verify the printer
setup is correct. If it is not set up properly, review the settings and try again.
NOTE: If the thin client disconnects from the server, the printer will need to be set up again the next
time the thin client connects.
70 Chapter 10 Prole Editor