HP ThinPro 7.0 - Administrator Guide

Registry key Description
root/Dashboard/GUI/Clock
If set to 1, the clock is shown on the taskbar.
root/Dashboard/GUI/DomainUser
If set to 1, the domain-user icon is shown on the taskbar if the
system is in domain-login mode.
root/Dashboard/GUI/PowerButton
If set to 1, the power button is shown on the taskbar.
root/Dashboard/GUI/Search
If set to 1, the Search button is shown on the taskbar.
root/Dashboard/GUI/SystemTray
If set to 1, the system tray is shown on the taskbar.
root/Dashboard/GUI/TaskBar
If set to 1, the application area is shown on the taskbar.
root/Dashboard/General/AutoHide
If set to 1, the taskbar auto-hides.
root/Dashboard/General/EnterLeaveTimeout
Sets the amount of time in milliseconds before the taskbar will
hide or show when AutoHide is enabled.
root/Dashboard/General/IconSize
Sets the size of the icons on the taskbar.
If set to -1, the size of the icon is based on the width of the
taskbar.
root/Dashboard/General/Length
Sets the length of the taskbar.
root/Dashboard/General/LengthToScreenSide
If set to 1, the length of taskbar is xed and equal to the length of
the side of the screen to which it is anchored.
root/Dashboard/General/PanelDockSide
Sets the side of the screen to which the taskbar is docked.
root/Dashboard/General/SlidingTimeout
Sets the amount of time in milliseconds that it takes for the
taskbar to hide or show when AutoHide is enabled.
root/Dashboard/General/Width
Sets the width of the taskbar.
If set to -1, the width is scaled based on the height of the primary
monitor.
Display
Registry key Description
root/Display/Configuration/Hotplug/
newMonitorPosition
On supported platforms, sets where new monitors should be
placed (either to the left or right of currently attached monitors)
when they are hotplug connected.
root/Display/Configuration/displaymode
Sets the display mode. If set to 0, the standard mode (a 1–4
monitor conguration) is used. If set to 1, a 6-monitor
conguration can be used, but only on supported platforms with
the appropriate add-on card.
root/Display/Configuration/hexlayout
Sets the layout in 6-monitor mode.
root/Display/Configuration/hexprofile
Sets the prole used in 6-monitor mode.
root/Display/Configuration/primaryprofile
Sets the prole to use for the primary monitor via the prole
name. For Smart Zero, this must always be set to default.
root/Display/Configuration/quaternarymode
Sets the position of the fourth monitor relative to the monitor
indicated in quaternaryrelative. This is hardware-
dependent and is not supported on all models. Values are dened
as follows: 0=Same As; 1=Above; 2=Right Of; 3=Left Of; 4=Below.
132 Appendix D Registry keys