Manualshelf

HP ThinPro 7.0 - Administrator Guide

ManualsBrandsHP ManualsDesktopsHP t520 Flexible Thin Client
51525354555657585960
IPSec rules
Use this tab to add, edit, and delete IPSec rules. An IPSec rule should be the same for each system that uses
IPSec to communicate.
When conguring an IPSec rule, use the General tab to set the rule’s information, addresses, and
authentication method. The Source Address is the IP address of the thin client, and the Destination Address is
the IP address of the system that the thin client is going to communicate with.
NOTE: Only the PSK and Certicate authentication types are supported. Kerberos authentication is not
supported.
Use the Tunnel tab to congure settings for tunnel mode.
Use the Phase I and Phase II tabs to congure advanced security settings. The settings should be the same
for all peer systems that communicate with each other.
NOTE: An IPSec rule can also be used to communicate with a computer running Windows.
Conguring VPN settings
HP ThinPro supports two types of VPN:
● Cisco
● PPTP
Enable the Auto Start option to start the VPN automatically.
Note the following about creating a VPN using Cisco:
● The Gateway is the gateway’s IP address or hostname.
● The Group name and Group password are the IPSec ID and IPSec password.
● The Domain setting is optional.
● The User name and User password are the user credentials that have rights to create a VPN connection
on the server side.
● The Security Type should be set the same as it is on the server side.
● The NAT Traversal option should be set according to your VPN environment.
● The IKE DH Group option sets the Die-Hellman group to use for VPN.
● The PFS Type option sets the Die-Hellman group to use for Perfect Forward Secrecy.
Note the following about creating a VPN using PPTP:
● The Gateway is the gateway’s IP address or hostname.
● The NT Domain setting is optional.
● The User name and User password are the user credentials that have rights to create a VPN connection
on the server side.
Conguring HP Velocity
Use the HP Velocity tab to congure HP Velocity settings. Go to http://www.hp.com/go/velocity for more
information about the HP Velocity modes.
System 47