HP ThinPro 7.1 - Administrator Guide

Registry key Description
(100 Mbps or 10 Mbps) and duplex mode (Full or Half) to
support switches and hubs that do not perform auto-negotiation.
root/Network/Wired/Profiles/<UUID>/IPv4/
Address
Sets the IPv4 address of the client. This setting takes eect only if
Method is set to Static.
root/Network/Wired/Profiles/<UUID>/IPv4/
DefaultGateway
Sets the default gateway that the device uses to communicate
with the Internet. Typically, this is the IP address of the router.
This setting takes eect only if Method is set to Static.
root/Network/Wired/Profiles/<UUID>/IPv4/
Enabled
If set to 1, IPv4 is enabled for this prole.
root/Network/Wired/Profiles/<UUID>/IPv4/
Method
If set to Automatic, the client uses DHCP to attempt to retrieve
network settings. If set to Static, the values of the Address,
SubnetMask, and DefaultGateway registry keys are used.
HP does not recommend using Static in a generic client prole,
because all clients would use the same IP address.
root/Network/Wired/Profiles/<UUID>/IPv4/
SubnetMask
Sets the subnet mask of the device, such as 255.255.255.0 (for a
standard class C subnet). This setting takes eect only if Method
is set to Static.
root/Network/Wired/Profiles/<UUID>/IPv6/
Address
Sets the IPv6 address of the client. This setting takes eect only if
Method is set to Static.
root/Network/Wired/Profiles/<UUID>/IPv6/
DefaultGateway
Sets the default gateway that the device uses to communicate
with the Internet. Typically, this is the IP address of the router.
This setting takes eect only if Method is set to Static.
root/Network/Wired/Profiles/<UUID>/IPv6/
Enabled
If set to 1, IPv6 is enabled for this prole.
root/Network/Wired/Profiles/<UUID>/IPv6/
Method
If set to Automatic, the client uses DHCP to attempt to retrieve
network settings. If set to Static, the values of the Address,
SubnetMask, and DefaultGateway registry keys are used.
HP does not recommend using Static in a generic client prole,
because all clients would use the same IP address.If set to
Automatic, the client uses DHCP to attempt to retrieve network
settings. If set to Static, the values of the Address,
SubnetMask, and DefaultGateway registry keys are used.
HP does not recommend using Static in a generic client prole,
because all clients would use the same IP address.
root/Network/Wired/Profiles/<UUID>/IPv6/
SubnetMask
Sets the subnet mask of the device, which is usually the IPv6
prex length. This setting takes eect only if Method is set to
Static.
root/Network/Wired/Profiles/<UUID>/MTU
Sets the MTU. It does not matter if the IP address is static or
acquired by DHCP.
root/Network/Wired/Profiles/<UUID>/Priority
Reserved for wired network.
root/Network/Wired/Profiles/<UUID>/Security/
EAPPEAP/AnonyIdentity
Sets the anonymous identity for PEAP authentication.
root/Network/Wired/Profiles/<UUID>/EAPPEAP/
CACert
Sets the path to the CA certicate le for PEAP authentication.
root/Network/Wired/Profiles/<UUID>/Security/
EAPPEAP/InnerAuth
Sets the PEAP inner authentication protocol.
136 Appendix D Registry keys