HP ThinPro 7.1 - Administrator Guide

Option Description
Hide window decorations This setting makes sure that screen elements such as the menu bar, minimize and
close options, and borders of the window pane are not displayed.
Window size Sets the window size to full, xed, or percent.
Percentage Size If Window Size is set to percent, this option sets the percentage of the screen that a
desktop window occupies.
NOTE: The resulting sizes might be rounded.
NOTE: RemoteFX supports only a xed list of resolutions.
Fixed Size If Window Size is set to xed, this option sets the width and height in pixels that the
desktop window occupies.
Options
The following table describes the settings that are available under the Options category when editing an RDP
connection.
Option Description
Enable motion events If enabled, mouse motions are continuously relayed to the RDP server.
Enable data compression Enables bulk compression of data between the RDP server and RDP client.
Enable deprecated RDP encryption Enables last-generation RDP encryption when NLA is not available.
Enable oscreen cache If enabled, o-screen memory is used to cache bitmaps.
Attach to admin console Attaches the connection to the administrator console port.
Cross-session copy/paste If enabled, copy and paste are enabled between dierent RDP sessions.
Enable buering of RDP6 primitives If enabled, non-RemoteFX graphics performance is increased at the cost of less frequent
screen updates.
Enable Progressive RemoteFX Codec Enables the RemoteFX Progressive Codec, which transmits the desktop in a series of
sharper and sharper images.
NOTE: This codec might cause visual artifacts on desktops with highly dynamic
content, so this codec can be disabled, if necessary.
Enable Multimedia Redirection Allows multimedia les to be sent directly to the client for local playback.
Certicate verication policy Select one of the following:
● Accept all RDP server certicates
● Use remembered hosts; warn if unknown or invalid certicate
● Skip remembered hosts; warn if unknown or invalid certicate
● Connect only to pre-approved RDP servers
TLS Version Sets the version of Transport Layer Security to be used during the early stages of
negotiation with the RDP server. Either set this to match the version of TLS used by your
RDP server, or try setting it to auto.
NOTE: There are some server-side defects in some unpatched RDP servers that can
cause the auto setting to fail, so it is not the default setting.
Send hostname as For per-device licensing, this selects how the client hostname is sent to the RDP server.
Select hostname or mac.
RDP 21