HP ThinPro 7.1 - Administrator Guide

RDP smart card redirection
By default, smart cards will be redirected using high-level redirection, allowing them to be used to log in to
the session and other remote applications.
To enable smart card login for an RDP connection:
▲ Select Use predened smart card in the RDP Connection Manager.
This will allow the user to connect without rst specifying credentials. The RDP client will start the RDP
session, and the user will be prompted to authenticate by smart card.
This technology requires drivers for the smart card reader driver to be installed on the thin client. By default,
the CCID and Gemalto drivers are installed, which adds support for the majority of smart card readers
available. Additional drivers can be installed by adding them to
/usr/lib/pkcs11/.
NOTE: When smart card login is enabled, Network Level Authentication is not supported and is
automatically disabled.
VMware Horizon View
VMware Horizon View per-connection settings
NOTE: These settings aect the connection you are currently conguring only.
Network
The following table describes the settings that are available under the Network category when editing a
VMware Horizon View connection.
Option Description
Name Enter a name for this connection.
Address Enter the hostname or IP address of a VMware Horizon View server.
Credentials ● Log in anonymously using unauthenticated access
● Use Single Sign-On credentials: The credentials used at login are also used to
start the connection.
● Ask for credentials at connection start: There are no pre-supplied credential
components.
● Use predened user, password, and/or domain: Some or all of the credentials are
stored and supplied for the connection.
● Use predened smart card: The connection is expected to be used with a smart
card for authentication.
User Enter the username to use for the connection.
Password Enter the password to use for the connection.
Domain Enter the domain to use for the connection.
General
The following table describes the settings that are available under the General category when editing a
VMware Horizon View connection.
VMware Horizon View 27