HP ThinPro 7.1 - Administrator Guide

Option Description
Name The connection name.
Type The XDMCP connection type. Valid options are: chooser, query, and broadcast.
Address This value is required if the Type value is set to query.
Use font server Use a remote X font server instead of locally installed fonts.
Font server Font server is not enabled unless the Use font server option is selected.
Congure display Select to set the display conguration for the connection. If you do not set this
conguration, the default conguration will be used.
Advanced
NOTE: See Advanced connection settings on page 10 for information about the settings available under the
Advanced category when editing a connection.
Secure Shell
NOTE: These settings aect only the connection you are currently conguring.
Conguration
The following table describes the settings that are available under the Conguration category when editing
an SSH connection.
Option Description
Name The connection name.
Address The IP address of the remote system.
Port The remote port to use for the connection.
User name The username to use for the connection.
Run application The application to run to make the connection.
Compression Select this option if you want to compress the data sent between the server and thin
client.
X11 connection forwarding If the server has an X server on it, select this option to allow the user to open user
interfaces from the SSH session and display them locally on the thin client.
Force TTY allocation Select this option and specify a command to initiate a temporary session to run the
command. Once the command has completed, the session will terminate. If no command
is specied, then the session will run normally as if the option were not selected.
Foreground color The default color of the text in the SSH session.
Background color The default color of the background in the SSH session.
Font Valid options are: 7X14, 5X7, 5X8, 6X9, 6X12, 7X13, 8X13, 8X16, 9X15, 10X20, and
12X24.
36 Chapter 5 Connection types