HP ThinPro PC Converter Deployment Tool - Administrator Guide
Table Of Contents
4 Installer USB ash drive
This option creates an image on the USB ash drive you can use in a 1:1 deployment model to install HP
ThinPro PC Converter onto most modern computers. The installer key operates similar to the bootable USB
ash drive key with the addition of the ability to install the image onto the target system.
Creating an installer USB ash drive
To create an installer USB ash drive:
1. Select Installer USB ash drive.
2. Follow steps 2 through 6 outlined in Creating a bootable USB ash drive on page 3.
Using the installer USB ash drive
After the system boots into HP ThinPro PC Converter from an installer USB ash drive, the HP ThinPro PC
Converter image oers the option to install that image onto the target system. For more details on this
process, refer to the HP ThinPro Administrator Guide.
NOTE: The installation option is disabled if the PC hardware does not meet the minimum requirements or if
the required licenses are missing.
4 Chapter 4 Installer USB ash drive