HP ThinUpdate - Administrator Guide

7 Deploying an image using a bootable USB
drive
You can use a bootable USB drive created with HP ThinUpdate to deploy an HP thin client image to another HP
thin client of the same model.
NOTE: You might be able to deploy an image to a ash drive smaller than that of the original, because the
size of a captured image does not necessarily equal the total capacity of the ash drive from which the image
was captured.
To deploy an image with a bootable USB drive created with HP ThinUpdate:
1. On the target thin client, make sure the rst boot device in the BIOS is set to USB.
2. Insert the USB drive, restart the thin client, and then follow the on-screen instructions.
8 Chapter 7 Deploying an image using a bootable USB drive