HP Velocity - Administrator Guide

44
Administrator Guide for Thin Clients | HP Velocity
flowinfo/flows
Description
The /proc/net/hp-velocity/flowinfo/flows file provides the ability to retrieve the flow information and
specifies the following parameters:
• RemoteIP: The remote IP address for the protected flow.
• RemotePort: The remote TCP or UDP port number for the protected flow. If the port number is a well-known protocol,
the protocol name also appears.
• LocalIP: The local IP address for the protected flow.
• LocalPort: The local TCP or UDP port number for the protected flow. If the port number is a well-known protocol, the
protocol name also appears.
• Protocol: The protocol (such as TCP or UDP) used by the protected flow.
• IPQ: Indicates the current IPQ state for a flow.
- L: Local flow, a single-sided acceleration from the local end point.
- P: Peered flow between two HP Velocity-enabled endpoints without a control channel.
- C: Connected flow between two HP Velocity enabled endpoints with a control channel to exchange telemetry infor-
mation.
- U: Unidentified state
• LiveTCP: The LiveTCP feature status.
- Enabled: LiveTCP is accelerating the flow.
- Monitoring: LiveTCP is enabled for the flow, but it is in monitoring to satisfy the correct network conditions to start
acceleration.
- Disabled: LiveTCP is disabled for this flow.
- N/A: LiveTCP is not applicable for this flow.
• LiveQ: LiveQ feature status.
- Enabled: Packet loss protection is enabled for the flow.
- Disabled: Packet loss protection is disabled for the flow.
- N/A: Packet loss protection is not applicable for this flow.
• TLR: The TLR that HP Velocity will attempt to achieve for the protected flow.
• Encoding: The encoding level applied to the protected flow.
Read / Write
• Read: Enter the following to query the flow details:
cat /proc/net/hp-velocity/flowinfo/flows