Troubleshooting Guide HP t520 Flexible Thin Client

Computer Setup—Security
NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.
Table B-1 Computer Setup—Security
Option Description
Setup Password Allows you to set and enable a setup (administrator) password.
NOTE: If the setup password is set, it is required to change Computer Setup options, flash the ROM, and
make changes to certain plug and play settings under Windows.
Power-On Password Allows you to set and enable a power-on password. The power-on password prompt appears after a
power cycle or reboot. If the user does not enter the correct power-on password, the unit will not boot.
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Allows you to enable/disable:
Stringent Password: This item only selectable while Setup Password is set.
NOTE: Disable the on-board password jumper’s (E49) ability to reset the setup passwords.
When enabling Stringent Password, losing the passwords may render the system permanently unusable.
Device Security Allows you to set Device Available/Device Hidden (default is Device Available) for:
●
System audio
●
Network controller
●
SATA Port 0
●
Mini PCIe Wireless LAN Device
USB Security Allows you to set Enabled/Disabled (default is Enabled) for:
●
Front USB Ports
◦
USB Port 8
◦
USB Port 9
●
Rear USB Ports
◦
USB Port 0
◦
USB Port 1
◦
USB Port 2
◦
USB Port 3
●
USB Port Configuration (Auto/Force 2.0). Lets you turn off USB 3.0 support (Force 2.0). The default
configuration is Auto, in which the operating speed of the USB port depends on the device and USB
port topology.
Slot Security Allows you to disable the PCI Express slot and Mini Card Slot. Default is enabled.
●
Mini Card Slot
Network Boot Enables/disables the computer’s ability to boot from an operating system installed on a network server.
(Feature available on NIC models only; the network controller must be either a PCI expansion card or
embedded on the system board.) Default is enabled.
Remote Wakeup Boot Source (Local Hard Drive/Remote Server)
System IDs Allows you to set:
●
Asset tag (18-byte identifier), a property identification number assigned by the company to the
computer.
20 Appendix B Computer Setup (F10) Utility, BIOS Settings