User Manual

Compliance with international regulations
All HP systems equipped with a laser device comply with appropriate safety standards including IEC
60825 and IEC 60950.
Laser product label
The following label or equivalent is located on the surface of your laser device. This label indicates
that the product is classified as a CLASS 1 LASER PRODUCT.
Symbols on equipment
The following table contains safety icons that may appear on HP equipment. Refer to this table for an
explanation of the icons, and heed the warnings that accompany them.
This symbol, when used alone or in conjunction with any of
the following icons, indicates the need to consult the operating
instructions provided with the product.
WARNING: A potential risk exists if the operating instructions
are not followed.
This symbol indicates the presence of electric shock hazards.
Enclosures marked with these symbols should only be opened
by a service partner.
WARNING: To avoid risk of injury from electric shock, do not
open this enclosure.
An RJ-45 receptacle marked with this symbol indicates a
Network Interface Connection (NIC).
WARNING: To avoid risk of electric shock, fire, or damage to
the equipment, do not plug telephone or telecommunications
connectors into this receptacle.
This symbol indicates the presence of a hot surface or
component. Touching this surface could result in bodily injury.
WARNING: To reduce the risk of injury from a hot component,
allow the surface to cool before touching.
These symbols indicate that the equipment is supplied by
multiple sources of power.
WARNING: To avoid risk of injury from electric shock, remove
all power cords to completely disconnect power from the
system.
28 Chapter 9 Electrical and mechanical safety