Maintenance and Service Guide

Table 5-4 Hard drive, hard drive bracket and hard drive cable descriptions and part numbers
Description Spare part number
Hard drive, 1 TB, 7200 rpm L06427-855
Hard drive cable M02050-001
Before removing the hard drive, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 29).
2. Remove the bottom cover (Bottom cover on page 29).
3. Disconnect the battery cable from the system board (see Battery on page 37).
Remove the hard drive:
1. Disconnect the hard drive cable from the system board ZIF connector (1).
2. Remove the three Phillips M2.0 × 2.5 screws (2) that secure the hard drive to the computer.
3. Remove the hard drive from the computer (3).
Reverse this procedure to install the hard drive.
If you need to disassemble the hard drive, follow these steps:
1. Remove the four Phillips M3.0 × 3.0 screws (1) that secure the bracket to the hard drive.
2. Remove the bracket from the hard drive (2).
34 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts