Installation Manual

41
Figure 31 Remove an interface module
Step3 If you do not install a new interface module in the slot, install the filler panel. To install an interface
module, see the chapter “Installing the UTM device.”
Replacing a CF card
CAUTION:
• To avoid hardware damage, do not remove the CF card when the UTM device is bootin
g
or the CF card
LED is blinking.
• To protect the CF card, place it into an antistatic bag.
Follow these steps to replace a CF card:
Step1 Make sure that the CF card LED is not blinking.
Step2 Press the CF card eject button so that the eject button projects from the panel.
Figure 32 Press the eject button
Step3 Press the eject button again to eject the CF card part way out of the slot, and then pull the CF card out
of the slot.