Specifications

Memory
Description
4-GB, PC3L-12800
2-GB, PC3L-12800
The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3/DDR3L-
SDRAM) dual inline memory modules (DIMMs).
DIMMs
The memory sockets on the system board can be populated with up to four industry-standard UDIMMs. These
memory sockets are populated with at least one preinstalled UDIMM. To achieve the maximum memory
support, you can populate the system board with up to 16-GB of memory configured in a high-performing
dual channel mode.
DDR3/DDR3L-SDRAM UDIMMs
For proper system operation, the DDR3/DDR3L-SDRAM UDIMMs must be:
●
industry-standard 240-pin
●
PC3/PC3L-12800 (1600 MHz) DDR3/DDR3L-SDRAM
●
1.5 volt DDR3-SDRAM UDIMMs / 1.35 volt DDR3L-SDRAM UDIMMs
The DDR3/DDR3L-SDRAM UDIMMs must also:
●
support CAS latency 11 DDR3/DDR3L 1600 MHz (11-11-11 timing)
●
contain the mandatory JEDEC SPD information
In addition, the computer supports:
●
2-Gbits and 4-Gbits non-ECC memory technologies
●
single-sided and double-sided UDIMMs
●
UDIMMs constructed with x8 and x16 DDR devices; UDIMMs constructed with x4 SDRAM are not
supported
NOTE: The system will not operate properly if you install unsupported UDIMMs.
Populating DIMM sockets
There are two DIMM sockets on the system board, with one socket per channel. The sockets are labeled
DIMM1 and DIMM3. Socket DIMM1 operates in memory channel A. Socket DIMM3 operates in memory channel
B.
Memory 25