HP EliteDesk 800 G3 Desktop Mini, HP ProDesk 600 G3 Desktop Mini, HP ProDesk 400 G3 Desktop Mini - Maintenance and Service Guide

4. Slide the drive toward the rear of the chassis until it stops, and then lift the hard drive up and out of the
cage (2).
NOTE: The power cable from the system board is located in the drive cage and disconnects when the
hard drive is removed.
Reverse this procedure to replace the hard drive. Make sure that the hard drive is fully seated into the SATA
connector BEFORE pushing down on the hard drive latch so that the latch will secure properly.
30 Chapter 4 Removal and replacement procedures – desktop mini (DM) chassis