Maintenance and Service Guide

Solid-state drive
Description Spare part number
Value SSD:
256 GB 865902-014
128 GB 827560-045
TLC:
512 GB 763008-016
256 GB 760615-044
128 GB 759848-025
Before removing the solid-state drive, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Remove the battery (see Battery on page 32).
4. Remove the optical drive (see Optical drive on page 34).
5. Remove the bottom cover (see Bottom cover on page 41).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE: Solid-state drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to install the solid-state drive.
50 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts