Instruction Manual

GUI event display
A problem that g enerates the Event display reduces the system capabilities. You can use the information
in this display (see Figure 66) to diagnose and correct problems.
NOTE:
The major diffe
rences between the Event Display and the Termination Event display are:
• The Event display includes an E IP t ype field; it does not include a Code Flag field.
• The Event display includes a Corrective Action Code (CAC) field.
• The Terminati
on Event display includes a Code Flag field; it does not include the EIP Type field.
Date
Time
SWCID
Evt No
CAC
EIP Type
Descrip-
tion
Figure 66 Typical HP Command View EVA Event display
The Event display provides the following information:
• Da te—The date the event occurred.
• Time—The time the even occurred.
• SWCID—Software Identification Code. A number in the range 1–256 that identifies the internal
firmware module affected.
• EvtNo—EventNumber.Ahexadecimalnumberintherange0–FFthatisthesoftwarecomponent
identification number.
• CAC—Corrective Action Code. A specific action to correct the problem.
• EIP Type—Event Information Packet Type. A hexadecimal character that defines the event
information format.
• Description—The problem that generated the event.
Fault management displays
When you do not have access to the GUI, you can display and analyze termination codes (TCs) on the
OCP LCD display. You c an then use the event text code do cument, as described in the section titled
“Interpreting Fault Management Information” to determine and implement corrective action. You can
also provide this information to the authorized service representative should you require additional
support. This lets the service representative identify the tools and components required to correct the
conditionintheshortestpossibletime.
When the Fault Manag ement display is active ( flashing), you can either d isplay the last fault or display
detailed information about the last 32 faults reported.
Displaying Last Fault Information
Complete the following procedure to display Last Fault information
1. When the Fault Management display is active (flashing) , press
toselecttheLastFaultmenu.
2. Press
to display the last fault information.
The first line of the TC display contains the eight-character TC error code and the two-chara cter IDX
(index) code. The IDX is a reference to the location in the TC array that contains this error. The
second line of the TC display identifies the affected parameter with a two-character parameter
number (0–30) , the eight-character parameter code affected, and the parameter code number.
3. Press
to return to the Last Fault menu.
156
Controller fault management