Instruction Manual

Application modules
The error log messages provided by application modules are listed in Table 24 and described in this
section.
Table 24 Application module—error log messages
DescriptionMessage
Number
Log messageID
Null doorbell routine for unloaded drivers.
When a driver is unloaded, the doorbell
routine is redirected to this null routine.
7
QLBA_NullDoorbell: driver unloaded,
port disabled
40967
Processing unsupported ordered-tag Task
Management command.
36
QLBA_ProcessTrb: Processing unsuppor-
ted ordered tag command
40996
Processing unsupported head-of-queue Task
Management command.
44
QLBA_ProcessTrb: Processing unsuppor-
ted head of queue tag command
41004
Unable to create object for target device: ex-
ceeded maximum number of target devices.
98
QLBA_CreateTargetDeviceObject: Too
many devices
41058
Unable to create object for target node: ex-
ceeded maximum number of target devices.
100
QLBA_CreateTargetNodeObject: Too
many devices
41060
Memory unavailable for LUN object.107
QLBA_CreateLUNObject: LUNObject
memory unavailable
41067
Unable to create object for initiator object:
exceeded maximum number of initiators.
117
QLBA_CreateInitiatorObject: Too many
initiators
41077
Process control block status indicates a PCI
error during a target operation.
136
QLBA_DisplayTargetOperationStatus:
PCI Error, Status 0x%.2x
41096
Process control block status indicates a DMA
error during an initiator operation.
146
QLBA_DisplayInitiatorOperationStatus:
DMA Error, Status 0x%.2x
41106
Process control block status indicates a trans-
port error (protocol) during an initiator opera-
tion.
147
QLBA_DisplayInitiatorOperationStatus:
Transport Error, Status 0x%.2x
41107
Process control block status indicates a data
overrun error during an initiator operation.
151
QLBA_DisplayInitiatorOperationStatus:
Data Overrun, Status 0x%.2x
41111
CHAP validation failed during login.393
QLIS_LoginPduContinue CHAP Valida-
tion Failure
41353
Unexpected CHAP key.394
QLIS_LoginPduContinue Unexpected
CHAP key detected
41354
Failed to allocate object for "Set Port Info"
IOCTL processing. PortType: 0 = FC, 1 =
iSCSI. PortId: 0 = FC1 or iSCSI1(GE1), 1 =
FC2 or iSCSI2 (GE2).
548
QLBI_SetPortInfo: QLUT_Allocate-
PortalObject failed (PortType 0x%x,
PortId 0x%x)
41508
Report LUNs command failed. The Report
LUNs command was issued by the
mpx100/100b as part of its discovery pro-
cess.
808
QLBI_GetLUNList: REPORT LUNS com-
mand failed
41768
Log data182