Instruction Manual

DescriptionMessage
Number
Log messageID
iSCSI login PDU received with an incorrect
initiator task tag for a session which is partially
logged in. This would occur if a login PDU
other than the initial login PDU used an initiat-
or task tag that was different from the initiator
task tag provided in the initial login PDU.
312
QLIS_LoginPduContinue:
CONN_STATE_IN_LOGIN, Unknown
InitTaskTag.
41272
iSCSI login PDU was received with a TSIH out
of range. This would occur if the iSCSI Initiator
attempting the login failed to used the TSIH
value provided in the target login response
PDU (the mpx100/100b is the target) in sub-
sequent login PDUs.
323
QLIS_LoginPduContinue: TSIH 0x%x out
of range
41283
iSCSI login PDU was received with an invalid
TSIH value. The TSIH is invalid because there
is no session with that TSIH value. This would
occur if the iSCSI Initiator attempting the login
failed to used the TSIH value provided in the
target login response PDU (the mpx100/100b
is the target) in subsequent login PDUs.
324
QLIS_LoginPduContinue: Session does
not exist, invalid TSIH 0x%x.
41284
Event notification: iSCSI driver encountered a
fatal error.
1688QLIS_HandleTeb: Driver Fatal Error42648
Event notification: an IOCTL request was re-
ceived to unload the iSCSI driver.
1689QLIS_HandleTeb: Unload Driver.42649
Event notification: an attempt to connect to the
iSNS server failed.
1694
QLIS_HandleTeb: iSNS Connection
Failed
42654
iSCSI driver
The error log messages for iSCSI drier are common to both iSCSI ports. The messages are listed and
described in Table 25. Log messages beginning with #0 apply to iSCSI port 1 (GE1) and log messages
beginning with #1 apply to iSCSI port 2 (GE2).
Table 25 iSCSI driver—error log messages
DescriptionMessage
Number
Log messageID
The iSCSI processor failed firm-
ware initialization.
262#%d: QLUtmIoctlEnable: Initialize FW failed73990
The iSCSI processor failed the in-
ternal loopback test.
328
#%d: QLRunDiag: MBOX Diag test internal loop-
back failed %x %x
74056
The iSCSI processor failed the ex-
ternal loopback test.
329
#%d: QLRunDiag: MBOX Diag test external loop-
back failed %x %x
74057
iSCSI FW did not send a valid
Continuation IOCB.
340
#%d: QLUtmReceiveScsiCmd: Invalid ATIO Continu-
ation type %x
74068
EVA iSCSI Connectivity User Guide 185