Instruction Manual

SNMP trap configuration
SNMP trap configuration supports setting up to eight trap destinations. Choose from Trap 1 to Trap
8 to configure each trap. Table 33 describes the parameters for configuring an SNMP trap.
Table 33 SNMP parameters
DescriptionParameter
Enables or disables trap n. If disabled, the trap is not configured.Trap n Enabled
Specifies the IP address to which the SNMP traps are sent. A maximum of
8 trap addresses are supported. The default address for traps is 0.0.0.0.
Trap Address
1
The port number on which the trap is sent. The default is 162.
Trap Port
1
Specifies the SNMP version (1 or 2) with which to format traps.Trap Version
1
Trap address (other than 0.0.0.) and trap port combinations must be unique. For example, if trap 1 and trap 2 have the same
address, then they must have different port values. Similarly, if trap 1 and trap 2 have the same port value, they must have
different addresses.
Management Information Base
The following sections describe the components of the Management Information Base (MIB):
• System information, page 196
• Network port table, page 197
• Fibre Channel port table, page 200
• Sensor table, page 202
System information
The system information objects provide the system serial number, version numbers
(hardware/software/agent), and number of ports (FC/GE).
qsrSerialNumber
SnmpAdminString
Syntax
read-onlyAccess
The system serial numberDescription
qsrHwVersion
SnmpAdminString
Syntax
read-onlyAccess
The system hardware version numberDescription
Simple Network Management Protocol196