Instruction Manual

Saving the configuration using the mpx100/100b CLI
To save the configuration using the mpx100/100b CLI:
1. Log in to the mpx100/100b using a Telnet session to the management port or the console port.
Username: guest
Password: password
2. Enter the following command:
mpx100> admin start
3. Enter config as the password.
4. Enter the following command:
mpx100 (admin) #> fru save
FRU save completed. Configuration File is HP_Storage-
Works_mpx100_FRU.bin. Please use FTP to extract the file out from the
System.
mpx100 (admin) #>
NOTE:
The FRU save creates a bin file containing the router’s persistent data, configuration, and LUN
mappings. The file is stored in the routers /var/ftp directory. You must then FTP the tar file
from the router.
5. Establish an FTP connection to the mpx100/100b management port and log in:
Username: ftp
Password: ftp
6. Enter the following command to set the FTP transfer type to Binary:
ftp> bin
7. Enter the following command to access the HP_StorageWorks_mpx100_FRU.bin file:
ftp> get HP_StorageWorks_mpx100_FRU.bin
Restoring the mpx100/100b configuration
There are two options for restoring configurations on the mpx100/100b:
• Full Configuration Restore—Fully restores the router’s configuration (all configuration parameters
and LUN mappings)
• Partial Restore (Mappings)—Restores only the LUN mappings
The restored configuration takes effect after the router is rebooted.
Restoring the configuration using the mpx100/100b GUI
To restore the configuration using the mpx100/100b GUI:
1. Select File > Restore FRU.
The Restore FRU dialog box is displayed.
Saving and restoring the mpx100/100b configuration220