Manual

NOTE:
It may take up to 10 minutes for the comp onent to display good status.
Check the disk drive status indicators. See Figure 9.
•Activityindicator(1)shouldbeonorashing
Online indicator (2) should be on or ashing
Fault indicator (3) should be off
Check the following using Command View EVA.
Navigate to the disk drive and check the operational state. It should be
.
•RecordtheModel number and the Firmware version.Checkthermware version against the
supported disk rmware in the HP StorageWorks Enterprise Virtual Array release notes.The
most current edition of the release notes can be downloaded from the following web site:
h
ttp://www.hp.com/go/eva5000
Click Technical documentation.
If the disk drive is using an unsupported version of rmware, download the correct rmware
from the following web site and install it using the instructions included with the rmware le.
Use the disk drive model number to locate the correct rmware le. Do not add the disk drive
to a disk group if it using an unsupported rmware version.
h
ttp://www.hp.com/support/evadiskrmware
Figure 9 Disk drive status indicators
1. Activity
2. Online
3. Fault
Adding the disk to a disk group
After replacing the disk, it should be added to a disk group.
1. In the N avigation pane, select Storage system > Hardware > Rack > Disk enc losu re > B ay
2. In the Content pane, select the Disk Drive tab.
3. Click Group to initiate the process for adding the disk to a disk group.
NOTE:
If the Device Addition Policy is set to automatic, the disk will automatically be added to a disk group. In
this case the Group option will not be available.
Enterprise Virtual Array 3000/5000 user guide
41