User Manual

Storage System Hardware Components
137Enterprise Virtual Array 3000 User Guide
If the feet are not fully raised, complete the following procedure:
1. Raise one foot by turning the leveler feet hex nut counterclockwise until the
weight of the rack is fully on the casters. See Figure 63.
2. Repeat step 1 for the other feet.
Figure 63: Raising a leveler foot
3. Carefully move the rack to the installation area and position it to provide the
necessary service areas. See Figure 61 or Figure 62.
To stabilize the rack when it is in the final installation location:
1. Use a wrench to lower the feet by turning the leveler feet hex nut clockwise
until the caster does not touch the floor
2. Repeat step 1 for the other feet.
3. After lowering the feet, check the rack to ensure it is stable and level.
4. Adjust the feet as necessary to ensure the rack is stable and level.
1 Hex nut
2 Leveler foot
1
2